Husqvarna 13C ユーザーズマニュアル

18 – 

English

1

Release the parking brake by first pressing down the 
parking brake pedal and then releasing it.

2

Carefully press down one of the pedals until the required 
speed is obtained. Pedal (1) is used to drive forwards, and 
pedal (2) to drive backwards.

3

Disengage the engine and select the required gear.

The lock button on the gear shift lever must be held in to 
engage reverse gear.

   - Gears 1-4 are used for mowing

   - Gears 4-5 are used for transporting

Starting can take place independent of which gear is 
engaged.

4

Select the required cutting height (1-7) with the cutting 
height lever.

It is important that the air pressure in both front wheels is 
equal, 60 kPa / 0,6 bar / 8.5 PSI, to produce an even 
cutting height.

5

Press in the lock button on the lifting lever and lower the 
cutting unit.

IMPORTANT! Gear changes between forward gears must 
not be made while the machine is moving.

The engine must be disengaged during each gear change.

Stop the machine before changing between forward and 
reverse gears, otherwise this may result in damage to the 
gearbox.

Never use force to engage a gear. If a gear does not engage 
immediately, release the clutch pedal and press it down 
again. Now try to engage the gear again.

The life span of the drive belts is increased significantly if 
the engine runs at a low speed when the blades are 
engaged. Therefore apply full throttle first when the cutting 
unit has been moved to the mowing position.