Husqvarna 13C ユーザーズマニュアル

English

 – 21

Clean the machine directly after use. It is much easier to wash 
off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. 
Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or 
bearings.

Do not rinse hot surfaces such as the engine and exhaust 
system.

Put the cutting unit in the service position first. Hose down the 
cutting unit with water underneath each time it is used.

It is recommended that you start the engine and run the 
mower for a short period after cleaning, so that any remaining 
water is blown off.

Lubricate the machine if necessary after cleaning. Carry out 
extra lubrication when the bearings have been exposed to a 
degreaser or a water jet.

There is a major risk of water penetrating into bearings and 
electrical connections. Corrosion attack can result, which will 
lead to running problems. Cleaning additives generally 
aggravate the damage.

The engine becomes accessible for service when the engine 
cover is opened.

Fold the seat forward, loosen the rubber strap under seat and 
fold the cover backwards.

Release the clip on the front hood and lift off the fender.

Remove the screws holding the wing cover (2 and 3). The 
knob (1) should also be removed on Rider 13 C, Rider 16 
AWD and Rider 16 C.

Remove the screws holding the wing cover (2) and lift off the 
cover.

IMPORTANT! Avoid using a high pressure washer or a 
steam cleaner.