Husqvarna 15V2 AWD ユーザーズマニュアル

16 – 

English

8

Let the engine run at moderate speed or half throttle for 3-
5 minutes before subjecting it to heavy load.

9

Set the required engine speed with the throttle control.

If the battery is too weak to start the engine, it should be 
recharged.

When jump leads are used for emergency starting, follow the 
procedure below:

•

Connect each end of the red cable to the POSITIVE pole 
(+) on each battery, exercise care not to short circuit any 
of the ends against the chassis.

•

Connect one end of the black cable to the NEGATIVE pole 
(-) on the fully charged battery.

•

Connect the other end of the black cable to a good 
CHASSIS EARTH, away from the fuel tank and the 
battery.

•

The BLACK cable is removed from the chassis and then 
the fully charged battery.

•

Finally the RED cable from both batteries.

1

Release the parking brake by first pressing down the 
parking brake pedal and then releasing it.

2

Carefully press down one of the pedals until the required 
speed is obtained. Pedal (1) is used to drive forwards, and 
pedal (2) to drive backwards.

3

Select the required cutting height (1-7) with the cutting 
height lever.

It is important that the air pressure in both front wheels is 
equal, 60 kPa / 8.5 PSI, to produce an even cutting height.

IMPORTANT INFORMATION Your Rider is equipped with a 
12-volt system with negative earth. The other vehicle must 
also have a 12-volt system with negative earth. Do not use 
your Rider battery to start other vehicles.

1

2