Husqvarna 15V2 AWD ユーザーズマニュアル

English

 – 25

The main fuse is placed in a detachable holder under the 
battery case’s cover, in front of the battery.

Type: Flat pin, 15 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector. Pull the fuse 
from the holder when replacing.

The fuse is there to protect the electrical system. If it blows 
again shortly after replacement, it is due to a short circuit, 
which must be fixed before the machine can be put into 
operation again.

The tyre pressure should be 60 kPa (0.6 kp/cm

2

/8.5 PSI) all 

round. To improve driving the pressure on the rear tyres can 
be reduced to 40 kPa (0.4 kp/cm

2

/5.6 PSI). The maximum 

tyre pressure is 100 kPa (1,0 kp/cm

2

/14 PSI).

Clean the air intake grille in the engine cover behind the 
driver’s seat.

Open the engine cover.

Check that the cooling intake is free from leaves, grass and 
dirt.

Check the air duct, located on the inside of the engine cover, 
ensure it is clean and does not rub against the cooling air 
intake.

A blocked cooling intake will interfere with the cooling of the 
engine, which can damage the engine.

1

Place the Rider on a flat surface and apply the parking 
brake. Check that the lever for setting the cutting height is 
in the lowest position.

Different tyre pressures on the front tyres will result in the 
blades cutting the grass at different heights.

1

2

3