Cub Cadet RZT-S ユーザーズマニュアル

P

P

P

P

P

P

P

P

P

Before performing any maintenance or 

repairs, disengage PTO, set parking brake, stop engine 

and remove key to prevent unintended starting.

The hydrostatic transmission is sealed at the factory and is 

maintenance-free. The fluid level cannot be checked and the 

fluid cannot be changed.

Refer to the Kohler Owner’s Manual for all engine maintenance 

procedures and instructions.
NOTE: Maintenance, repair, or replacement of the emission control 

devices and systems which are being done at owner’s expense may 

be performed by any engine repair establishment or individual. 

Warranty repairs must be performed by a Cub Cadet Dealer.

If the engine has been recently run, the 

engine, muffler and surrounding metal surfaces will 

be hot and can cause burns to the skin.  Exercise 

caution to avoid burns.

To complete an oil change, proceed as follows:
1. 

Run the engine for a short time to warm the engine oil. The 

oil will flow more freely and carry away more impurities. 

Use care to avoid burns from hot oil.

2. 

Locate the oil drain port on the right side of the engine.

3. 

Route the free end of the oil drain hose toward an 

appropriate oil collection container with at least a 2.5 quart 

capacity, to collect the used oil. Remove the oil fill cap/

dipstick from the oil fill tube.

4. 

While holding the free end of the oil drain hose over the oil 

collection container, unscrew the square head hose plug 

from the end of the hose. See Figure 6-1. Drain the engine 

oil into the collection container.

5. 

After draining the oil, wipe any residual oil from the oil 

drain hose. Thread the square head plug into the drain 

hose fitting and fully tighten the plug.

6. 

Replace the oil filter, and refill the engine with new oil as 

instructed in the Kohler Owner’s Manual.