Ariens Pro-24 HWSP ユーザーズマニュアル

GB - 15

See Figure 16 for locations.

The Operator Presence Control (OPC) lever 
must be held against the handlebar to start 
the engine and blade.

Releasing the OPC lever grounds engine 
spark and applies engine flywheel brake, 
stopping the engine and blade within 3 
seconds. Check this feature frequently. If 
feature fails to operate, disconnect spark plug 
wire and adjust or have it repaired before 
using unit.

When pulled, recoil starter handle will turn 
engine over.

Push throttle forward to 
increase engine speed. 
Pull throttle backward to 
decrease engine speed.

The lower, right-side lever must be manually 
held against the handlebar to engage wheel 
drive. Wheel drive will disengage when this 
lever is released. This lever allows for quick 
engagement and disengagement of wheel 
drive when maneuvering in tight areas or 
around obstacles.

NOTE: Engine must be running for wheel 
drive to propel unit.

Wheel drive speed is preset and cannot be 
varied during mower operation. The drive 
speed may be changed by adjusting the 
variable speed (VS) pulley configuration. See 
Wheel Drive Speed Adjustment on page 24.

WARNING: Improper operation 
can lead to injury. Learn what the 
controls do and how they work. 
Thoroughly read and understand 
entire Operator Manual.

CAUTION: DO NOT operate 
mower unless side discharge 
deflector is installed. Thrown 
objects may cause damage or 
injury.

CAUTION: If clog or obstruction 
prevents grass flow, release 
engine/blade control and 
disconnect spark plug wire before 
attempting to clear away any 
clogs.

CAUTION: Check function of 
Engine/Blade Control regularly. 
Improper function of control could 
cause injury.