Cub Cadet Z-Force S ユーザーズマニュアル

• 

One Lawn Tractor

• 

One Oil Drain Hose (If equipped)

• 

One Deck Wash Hose Coupler 

• 

One Z-Force S  Tractor Operator’s 

Manual

• 

One Engine Operator’s Manual

1.  Remove the upper crating material from the shipping pallet, 

and cut any bands or tie straps securing the tractor to the 

pallet. 

2.  If the deck is not in the highest mowing position (pushed all 

the way forward), use the deck lift pedal to raise the deck to 

its highest position. Refer to the Controls & Features section 

for instructions on raising and lowering the deck.

3.  Disengage the parking brake.
4.  Engage the transmission bypass rods on each side of the 

tractor; then carefully roll the tractor off the shipping pallet. 

The transmission bypass rods (one for each the RH and LH 

transmission) are located on the rear of the tractor, just 

inside each rear wheel. Disengage the bypass rods.  See Fig. 

3-1.

5.  Remove the deck wash system nozzle adapter and oil drain 

tube (if so equipped) from the manual bag and store for 

future use. 

The steering wheel column is tilted all the way back for shipping 

purposes. To tilt the column forward, press the steering tilt pedal. 

Release the steering tilt pedal when the column is in the desired 

position.

1. 

Remove the hardware for attaching the steering wheel 

from beneath the steering wheel cap. Carefully pry off the 

steering wheel cover to remove the hardware.

2. 

With the wheels of the tractor pointing straight forward, 

place the steering wheel over the steering shaft.

3. 

Place the flat washer and belleville washer over the 

steering wheel and secure with the hex screw. See Fig. 3-2.

4. 

Place the steering wheel cover over the center of the 

steering wheel and push downward until it “clicks” into 

place.

To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan 

attached. A second person may be needed to to hold the seat.
1. 

Cut any straps securing the seat assembly to the tractor. 

Remove any packing material.

NOTE: Be careful not to cut the wiring harness connecting the 

seat and the seat switch in the bottom of the seat.