Cub Cadet LT1022 ユーザーズマニュアル

18

 Refer to Maintenance Chart on page 24 for a

reference of recommended maintenance intervals.

Before performing any

maintenance or repairs, disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.

Check engine oil level before each use as instructed in 
the 

Briggs & Stratton Operator/Owner Manual packed 

with your unit. Follow the instructions carefully.

Maintenance, repair, or replacement of the emission 
control devices and systems, which are being done at 
the customer’s expense, may be performed by any 
engine repair establishment or individual. Warranty 
repairs must be performed by your 

•

Gently raise the tractor’s hood

•

Unscrew the oil fill cap and remove the dipstick 
from the oil fill tube. See Figure 13.

•

Pop open the protective cap on the end of the oil 
drain valve to expose the drain port. See Figure 13.

•

Push the oil drain hose (packed with this manual) 
onto the oil drain port. Route the opposite end of 
the hose into an appropriate oil collection container 
with a capacity of no less than 64 oz.

•

Push the oil drain valve in slightly, then rotate 
counterclockwise and pull outward to begin 
draining oil.

•

Service the oil filteras instructed in the separate 
Briggs & Stratton Operator/Owner Manual packed 
with your unit.

Perform the above steps in the opposite order after oil 
has finished draining. 

•

Refill the engine with new motor oil.

 Refer to the 

Briggs & Stratton Operator/

Owner Manual packed with your unit for information 
regarding the quantity and proper weight of motor oil.

Service the pre-cleaner and cartridge/air cleaner 
element as instructed in the 

Briggs & Stratton Operator/

Owner Manual packed with your unit.

The spark plug(s) should be cleaned and the gap reset 
once a season.  Refer to the 

Briggs & Stratton

Operator/Owner Manual for correct plug type and gap 
specifications.

Any fuel or oil spilled on the machine should be wiped 
off promptly. 
Do NOT allow debris to accumulate around the cooling 
fins of the engine or on any other part of the machine, 
especially the belts and pulleys.

 The use of a pressure washer or garden 

hose to clean your tractor is NOT recommended. It may 
cause damage to electrical components, spindles, 
pulleys, bearings or the engine. The use of water will 
result in a shortened life of the tractor and reduce its 
serviceability.

Before lubricating, repairing, or

inspecting, always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.

Refer to Engine on page 18 for instruction regarding all 
engine-related lubrication.

Lubricate all the pivot points on the drive system, 
parking brake and lift linkage at least once a season 
with light oil.

Each of the tractor deck’s front gauge wheels is 
equipped with a grease fitting. Lubricate with a grease 
gun after every 25 hours of tractor operation