American Standard 2425.218WC プリント
HAMPTON™ 5’ INTEGRAL APRON
WHIRLPOOL
HIGH GLOSS ACRYLIC
HAMPTON™ 5’ INTEGRAL APRON WHIRLPOOL
❏
2425.218W Whirlpool featuring System I
Left Hand Drain Outlet
❏
2425.118W Whirlpool featuring System I
Right Hand Drain Outlet
• Acrylic with fiberglass reinforcement
• Integral apron with removable access panel
• Integral three-sided, tiling / water retention
Right Hand Drain Outlet
• Acrylic with fiberglass reinforcement
• Integral apron with removable access panel
• Integral three-sided, tiling / water retention
flange
• Form-fitted backrest
• 1.5 HP single speed, self-draining pump/motor
• 1.5 HP single speed, self-draining pump/motor
with dry run seal
• Factory-installed power cord with plug
• Eight multi-directional and flow-adjustable jets
• Eight multi-directional and flow-adjustable jets
including:
- Two Ideal-flow jets
- Four body massage jets
- Two recessed back-rest jets
- Four body massage jets
- Two recessed back-rest jets
• Deck-mounted air switch On/Off
• Two silent air volume controls
• Quick Connect Safe-T-Heater connection
• Two silent air volume controls
• Quick Connect Safe-T-Heater connection
system
• Factory installed and tested whirlpool system
StayClean™ Whirlpool Massage featuring System I
❏
2425.218WC Whirlpool featuring System I
Left Hand Drain Outlet
❏
2425.118WC Whirlpool featuring System I
Right Hand Drain Outlet
Right Hand Drain Outlet
• Same as above except with the StayClean™
whirlpool system featuring Antimicrobial
AlphaSan®
AlphaSan®
Nominal Dimensions:
60” x 32” x 21-1/2” (1524 x 813 x 546mm)
60” x 32” x 21-1/2” (1524 x 813 x 546mm)
© 2003 American Standard Inc.
BV-19
3/03
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• Underwriters Laboratories - Hydromassage
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
NOTE: Roughing-in dimensions and product
specifications shown on reverse side of page.
specifications shown on reverse side of page.
To Be Specified - Required:
❏
Color:
❏
Bath Faucet: (specify finish)
❏
Bath Drain: 1583.470 (specify finish)
To Be Specified - Optional:
❏
Safe-T-Heater*: 9075.120
❏
Bath Caddie: 9533.100 (in Chrome only)
❏
Jet Trim Ring Kit: 9860.200-two per kit (specify finish)
For color/finish availability and other faucet choices,
please see the Product Selector and Pricing Guide.
please see the Product Selector and Pricing Guide.
* NOTE: the Safe-T-Heater is designed to maintain water
temperature during operation. It will not heat cold water to
desired bathing temperature.
temperature during operation. It will not heat cold water to
desired bathing temperature.