Dimension One Spas Sarena Bay ユーザーズマニュアル
2003 Sarena Bay™
Export Owner’s Manual
Troubleshooting Guide
Heating System
Symptom
Problem
Corrective Action
1.
Temperature setting is
too low
too low
1.
Turn up the thermostat
2. Dirty
filter
2. Clean
filter
Does not heat
3. Flow
switch
malfunction 3.
Call for service
1.
Temperature setting is to
high
high
1.
Turn down the thermostat
Too hot
2.
High limit tripped
2.
Call for service
Erroneous
temperature of
0° C (≅32°F)or
57.8° C (≅136°F)
appears on the
display
temperature of
0° C (≅32°F)or
57.8° C (≅136°F)
appears on the
display
Possible temperature sensor
failure
failure
Call for service
Hot Tub
Temperature
erratic
Temperature
erratic
Water level
Fill with water to the bottom of the OptiMount™ located next to the
Skimmer Basket.
Skimmer Basket.
1.
Too much filtration
1.
Reduce the number of filter cycles and/or the filter cycle duration
2.
Temperature setting too
high
high
2.
Turn down the thermostat
Display reads
OVERHEAT
OVERHEAT
3.
High limit or sensor
problem
problem
3.
Call for service
Electrical System
Symptom
Problem
Corrective Action
Will not turn on
– in any mode
– in any mode
No power
Check circuit breaker and/or GFCI
Turns on by itself
Normal automatic daily
power filtration, or anti-
freeze cycle
power filtration, or anti-
freeze cycle
No action required
Light is out
Burned out bulb
Replace bulb
1. Automatic
timer
has shut pump off
1.
Push JETS pad again to start another cycle
Pump shuts
down
unexpectedly
while in use
down
unexpectedly
while in use
2. Motor
over-heated
and automatic
protective device
has shut down
pump(s)
protective device
has shut down
pump(s)
2.
If pump(s) will not restart when JETS pad is pushed, call for service
Make sure that the equipment panel vent area is not blocked. Vent blockage
can cause serious damage to your equipment.
Make sure that the equipment panel vent area is not blocked. Vent blockage
can cause serious damage to your equipment.
47