Jacuzzi Comfort Plus Bath Series ユーザーズマニュアル
ENGLISH
3
Jacuzzi Whirlpool Bath
©
BP43000 2/05
ROUGHING-IN REFERENCE
(RECTANGULAR)
*Add 1/4" to this dimension when roughing-in for 3-wall niche.
9"
CETRA 536 PLUS WITH INTEGRAL SKIRT
*60"
36"
17-3/8"
12" x 4"*
(Left hand shown. Right hand is mirror image.)
SIGNA 5 PLUS
60"
12"
42"
5"
4-1/4"
13" x 5"
30"
(Right hand only.)
12-1/2"
36"
11 -1/4"
5"
42"
72"
18-1/2" x 5"*
SIGNA 6 PLUS
(Right hand only.)
Note:
1. Baths shown are left-hand unless otherwise specified. Right-hand is a mirror image.
2. Some units have been provided with cutout templates included in shipping carton.
See CUTOUT information for each model on page 1 and 2.
3. THE OVERALL DIMENSIONS ARE NOMINAL WITH A TOLERANCE OF +0 AND -1/4".
4. Measurements inside each unit represent cutout in floor to allow for drain/overflow.
5. All measurements are in inches. To convert to millimeters, multiply inches by 25.4.
2. Some units have been provided with cutout templates included in shipping carton.
See CUTOUT information for each model on page 1 and 2.
3. THE OVERALL DIMENSIONS ARE NOMINAL WITH A TOLERANCE OF +0 AND -1/4".
4. Measurements inside each unit represent cutout in floor to allow for drain/overflow.
5. All measurements are in inches. To convert to millimeters, multiply inches by 25.4.
AMIGA PLUS
72''
18''
36''
2''
16'' x 4''*
14''
(Left hand only)
ROUGHING-IN REFERENCE
(OVAL AND CORNER)
42"
72"
3"
36"
11"
(Right-hand only.)
13" X 6"*
LUNA PLUS
- 2" x 4" Stud
TARA PLUS
27-1/4"
35"
44"
60"
60"
46"
27-1/4"
35"
14" x 4"*
Ref.
61-5/8"
(Right hand only)
CUTOUT- CORNER BATH
SUPPORT FOR CORNER BATHS
H
2" x 4" STUD
APPLY
ADHESIVE
ADHESIVE
25-1/2"
(648 mm)
58"
(1473 mm)
45-9/16"
(1157 mm)
TARA PLUS
58"
(1473 mm)
25-1/2"
(648 mm)
Ref.
59"
CUTOUT
Corner Baths with Skirt
If an optional skirt is used on a corner bath, additional support is
necessary in the front of the unit. Measure the height from the floor
to the underside of the bath rim. Cut two 2" x 4" studs, apply adhe-
sive to both ends and install.
to the underside of the bath rim. Cut two 2" x 4" studs, apply adhe-
sive to both ends and install.