North Star M1578112G ユーザーズマニュアル

  

 

16

Serious injury or death can result if chemical manufacturer instructions are not 

followed.
-Wear protective gloves when handling and cleaning with chemicals. 
-Understand all safety hazards and first aid for all chemicals being used.
-When cleaning filters, check if chemicals have been used and take any 

precautions that are recommended by the chemical manufacturer.

-Different chemicals may interact dangerously with each other, always follow 
chemical manufacturer directions before switching chemicals.
-Calculate the correct amount of chemical to mix, dispose of excess chemical 

per the manufacturer instructions. 

-Never spray flammable liquids. 

 
Applying Chemicals 
1.) Install the black nozzle to spray chemicals onto the cleaning surface.  
2.) Start the pressure washer according to the start-up instructions.  
3.) Submerge the chemical hose in cleaning solution. (See Pump Component   Identification section 
for chemical injector location.) 
4.) Squeeze the spray gun trigger.  The chemical injector will draw the chemical into the water 

stream. 

5.) Apply chemicals evenly onto the cleaning surface.  Allow the chemicals to react with the dirt, then 

clean at high pressure with green nozzle. 

6.) Never use more chemical than is necessary to clean the surface. 
7.) To clean the chemical injector, draw water through the strainer until all the chemical is purged 

from the system.