Ariens 926500 ST1332DLE ユーザーズマニュアル

GB - 24

If chute does not rotate freely:

Tighten the cable by loosening the upper adjustment 
nut, and then tightening the lower adjustment nut 
against the bracket (Figure 28).

To adjust (Figure 29):

1. Place unit into service position.

2. Disconnect adjustment pivot pin from speed 

selector lever by removing hair pin.

3. Place the speed selector in the fastest forward 

speed position.

4. Turn the speed selector lever straight down 

towards the ground as far as it will go.

5. Thread the adjustment pivot pin along the shift 

rod until it aligns with the mating hole on the 
speed selector lever. Insert the pivot pin into hole.

6. Secure adjustment pivot pin with hairpin.

7. Make sure the speed selector shifts into each 

speed position.

(Figures 30, 31 and 32)

1. Remove the belt cover.

2. Loosen jam nut on cable adjustment barrel, and 

then turn the adjustment barrel up or down to 
lengthen or shorten cable and remove all cable 
slack. See Figure 30.

Tighten upper 
adjustment nut.

Loosen lower 
adjustment nut.

Figure 27

OS7180

Loosen upper 
adjustment nut.

Tighten lower 
adjustment nut.

Figure 28

OS7180

IMPORTANT: IMPROPER ADJUSTMENT 
could result in unexpected movement of 
auger and impeller causing death or serious 
injury. Auger / impeller must stop within 5 
seconds when Attachment Clutch/Impeller 
Brake lever is released.

Figure 29

1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin

OS7185

Figure 30

1. Attachment Clutch Cable
2. Adjustment Barrel
3. Jam Nut

OS7185

OS7191