Ariens 03883300A ユーザーズマニュアル

ページ / 32
GB - 17
MAINTENANCE SCHEDULE
The chart below shows the recommended 
maintenance schedule that should be 
performed on a regular basis. More frequent 
service may be required.
 
*
 After first five hours of operation.
**
 After first two hours of operation.
CHECK DUAL HANDLE 
INTERLOCK 
Without the engine running, press down 
(engage) both clutch levers. Release 
attachment clutch lever. Attachment clutch 
should remain engaged until traction clutch 
lever is released, then both clutches must 
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK CLUTCH OPERATION
Auger / impeller must stop within 5 seconds 
when attachment clutch/impeller brake lever 
is released.
Wheels must stop quickly when traction drive 
clutch lever is released.
If clutches do not engage or disengage 
properly, adjust or repair before operation 
(see Attachment Clutch/Brake Adjustment on 
page 23 and Traction Drive Clutch 
Adjustment
 on page 25).
CHECK CLUTCH SPRING 
ADJUSTMENT
Make sure the attachment clutch and traction 
drive clutch are adjusted to the range 
specified in Attachment Clutch/Brake 
Adjustment
 on page 23 andTraction Drive 
Clutch Adjustment
 on page 25.
CLEAN ENGINE
Refer to engine manual for detailed 
instructions.
CHECK ENGINE OIL
The engine crankcase oil should be checked 
every 5 hours of operation. Oil level MUST be 
maintained in safe operating range on 
dipstick at all times or engine damage will 
result (See engine manual).
Park unit on a level surface. Refer to engine 
manual for detailed instructions.
CHANGE ENGINE OIL
Change oil after first 2 hours of operation, 
thereafter change oil every 25 hours (more 
often if required). Refer to engine manual for 
detailed instructions.
Run engine just prior to changing oil. Warm 
oil will flow more freely and carry away more 
contamination. Remove the oil drain plug 
from the side of the unit and tip the unit  to 
help drain all the oil.
CHECK TIRE PRESSURE
Keep tires at pressure listed on the tire 
sidewall (see Check Tire Pressure on 
page 10).
CHECK AUGER GEARCASE 
IMPORTANT: Proper oil level must be 
maintained.
Gear cases are filled to the correct level at 
the factory. Unless there is evidence of 
leakage, no additional lubricant should be 
required. Check oil level each season or 
every 25 hours of operation.
MAINTENANCE SCHEDULE
Service 
Performed
Each 
Use
Every 
5 hrs.
Every 
25 
hrs.
Yearly
Check Dual 
Handle 
Interlock
Check 
Fasteners
Check Clutch 
Operation
Check Clutch 
Spring 
Adjustments
*
Clean Engine
Check Engine 
Oil
Change 
Engine Oil
**
Check Tire 
Pressure
Check Auger 
Gearcase
General 
Lubrication