Bolens 3BA サービスマニュアル

IMPORTANT: This unit is shipped with the engine full of 
oil. After assembly, see page 9 for fuel and oil details. 

NOTE: Reference to right, left, front or rear of the unit is 
from the operating position unless otherwise stated. 
1.  Cut the cable tie that secures the upper handle to 

the chute assembly for shipping purposes.

1.  Loosen the chute knob on the upper chute(1) and 

pivot the upper chute upwards(2) as far as it will go. 
See Figure 1.

2.  Loosen the handle knob, saddle washer and handle 

tab on each side of the handle. See Figure 2.

3.  Hold both controls against upper handle and pull up 

as shown in Step 1 of Figure 3. Make sure that the 
upper handle locks over the lower handle and handle 
tabs align with the handle. You may have to carefully 
maneuver the upper handle to clear chute assembly.

CAUTION: Be careful not to bend or kink the cable.
4.  Tighten the handle knobs on each side of the 

handle. Refer to Step 2 in Figure 3.

5.  Adjust upper chute and rotate chute handle to 

desired operating position. 

6.  Tighten the chute knob on the upper chute making 

sure the flat washer and the carriage bolt are 

correctly positioned. Refer to Figure 1.

This tool and the electric extension cord, if so equipped, 

may be fastened with a cable tie to the rear of the auger 

housing for shipping purposes. In that case, cut the 

cable tie and remove the extension cord now.

IMPORTANT:  Check the adjustments as instructed and 

make any final adjustments necessary before operating 

the unit. Check all nuts and bolts for tightness. Failure to 

follow these instructions may cause damage to unit. 

The tires are over-inflated for shipping purposes. Check 

tire pressure and reduce pressure, if needed. Refer to 

the tire’s sidewall for the proper inflation PSI information. 

Maintain equal pressure on both wheels of snow thrower.

NOTE: 

1

2

1