MTD Troy-Bilt ユーザーズマニュアル

IMPORTANT: The snow thrower is shipped with oil and 
WITHOUT GASOLINE. After assembly, refer to separate 
engine manual for proper fuel and engine oil recom-
mendations.

•  The augers are secured to the auger shaft with shear

pins and bow tie cotter pins. If you hit a foreign object 
or ice jam, the snow thrower is designed so that the 
pins may shear. Replacement shear pins and cotter 
pins are provided for your convenience. Store these 
safely until needed.

Pair of pliers  

7/16” Wrenches or adjustables 

Fresh gasoline

•  Look at the lower rear of the snow thrower frame to 

be sure the spring (found at the end of each cable) is 
attached to its actuator bracket. 

•  Remove the lower handle knobs, washers and

carriage bolts from each side of the upper handle. 
See Figure 3-2.

•  Raise the upper handle assembly until it locks over 

the lower handle.  See Figure 3-1.

•  Secure the upper handle and lower handle with the 

handle knobs and carriage bolts previously removed. 

•  Tighten the handle knobs already in place on the 

upper holes and secure the handles firmly.

•  Remove the flat washer and hairpin clip from the end

of the chute directional control. See Figure 3-3.

•  Insert the end of the chute directional control into

the lower bracket and secure with the flat washer 
and hairpin clip just removed. If necessary, the lower 
bracket can be adjusted. Refer to Chute Bracket 
Adjustment, in the Adjustment Section of this manual.

•  Remove locknuts and screws securing one of the

flange keepers to the chute assembly. See Figure 3-4.

•  Loosen but do not remove the locknuts and screws on

the other two flange keepers.

NOTE: This Operator’s 
Manual covers several 
models. Snowthrower 
featrues vary by model.  
Not all features refer-
enced in this manual 
are applicable to all 
snowthrower models.

NOTE: References to 
right or left side of the 
snow thrower are deter-
mined from behind the 
unit in the operating 
position.

NOTE: Replacement 
auger shear pins and 
cotter pins are provided 
for your convenience. 
Store these safely until 
needed.