John Deere ST0521M ユーザーズマニュアル

22

MTF-031039C

1. Remove the belt cover. See “How To Remove The Belt

Cover”.

2. Remove the drive belt. See “How To Replace The Drive

Belt”.

3. Remove the auger pulley from the auger shaft

(threads are left hand; turn clockwise to remove). (See
Figure 23).

4. To keep the auger from rotating, set a 2”x4” piece of

wood on the center paddle to secure auger.

5. Remove the fasteners from the bearing assembly. Re-

move the bearing assembly from the auger housing.

6. Slide the auger out of the bearing assembly on the

right side of the snow thrower.

7. Tip the auger enough to allow the auger to slide out of

the auger housing.

8. To install auger, reverse the above steps.

Figure 23

Bearing Assemlby

Auger Pulley

Auger Housing

Auger

Center Paddle

Wood