Cub Cadet 221 HP ユーザーズマニュアル

Align the holes in the chute base with the holes in the 

3. 

lower chute and secure with the previously removed hex 

washer screws. See Fig. 3-5.

Remove the eye bolt and handle knob from the manual 

1. 

bag.
Place the eye bolt and handle knob on the upper handle as 

2. 

shown in Fig. 3-6. Do not fully tighten the hardware until 

instructed to do so.

NOTE: The opening of the eye bolt should face toward the 

back of the snow thrower.
Slowly pull the recoil starter handle up towards the eye 

3. 

bolt.
Slip the recoil starter rope into the eye bolt from the back 

4. 

side of the snow thrower. See Fig. 3-6.
Securely tighten the eye bolt and handle knob.

5. 

Place the chute handle on the lower chute as shown in Fig. 

1. 

3-3. Be certain that the handle is aligned in the channel on 

the chute and the tabs snap into place.

Remove the hex washer screws in the chute base. See Fig. 

2. 

3-4.