John Deere ST1332 ユーザーズマニュアル

13

MTF−051059L

1. Cut tie holding shift rod to lower handle and move shifter

to the neutral position.

2. The fasteners that secure the upper handle to the lower

handle are mounted in the handles. Loosen, but do not

remove these fasteners (see See Figure 5).

3. The remaining fasteners are mounted in either the upper

handle or the lower handle.  To allow the handle to be

raised to the operating position, remove these fasteners.

4. Raise upper handle to the operating position. The upper

handle must be to the outside of the lower handle.

5. Install the fasteners that were removed in step 3. DO

NOT tighten until all bolts are in place.

6. Tighten all handle bolts.

Figure 5

Nut

Flatwasher

Bolt

Lockwasher

Lower Handle

Upper Handle

Figure 6

Lever

“Z” Fitting

Control Cable

If control cables have become unattached from motor mount

frame, reconnect cables as shown in Figure 7.

Traction Drive Cable

Auger Drive Cable

Figure 7

The cables were adjusted at the factory and no adjustments

should be necessary. However, after the handles are put in

the operating position, the cables can be too tight or too

loose. If an adjustment is necessary, see “How To Check And

Adjust The Cables” in the Maintenance section.