John Deere ST1332 ユーザーズマニュアル

14

MTF−051059L

1. Assemble the remote chute knob onto the lever until

snug against the nut (see Figure 8).

2. Make sure lip on the remote chute knob is pointed to-

ward the engine.

3. Tighten the nut against the bottom of the remote chute

1. Thread the knob onto the lever as far as possible. Make

sure that the knob points forward  (See Figure 8).

2. Tighten the jam nut against the knob securely.

Figure 8

Remote Chute 

Control Knob

Nut

3/8”

Lever

LIp

1. Put the speed select lever to the NEUTRAL position.

See Figure 9.

2. Attach the ball joint, located on the bottom end of the

speed control rod, to the shift yoke assembly. See

Figure 10. The fasteners  (washer and nut) are in the

parts bag.

3. The length of the ball joint and speed control rod have

been pre−adjusted at the factory. If an adjustment is re-

quired, loosen the nut. Remove the fasteners to discon-

nect the ball joint from the shift yoke assembly. To

lengthen or shorten the speed control rod, turn the

adapter to obtain the correct length. 

4. Make sure the speed select lever functions correctly.

Move the speed select lever through all speeds.

Speed Select Lever

Figure 9

Figure 10

Ball Joint

Speed Control

Rod

Shift Yoke

Assembly

Fasteners

Nut

Adapter