John Deere ST1332 ユーザーズマニュアル

OPERATION

MTF--051059L

HOW TO USE THE WHEEL LOCKOUT

Each wheel is secured to the axle with a lockout pin. See

Figure 14. The unit was shipped with the lockout pin in the

locked position. For ease of maneuverability, disconnect the

lockout pin as follows.
1. Pull the knob out to disengage the lockout pin.
2. To lock in the disengaged position, turn the knob 1/4 turn

(90 degrees).

NOTE: Check tire pressure. See side of tire for maximum

inflation. Do not exceed listed maximum pressure.

Figure 14

Knob

Wheel Lockout

HOW TO SET THE DRIFT CUTTERS

(OPTIONAL ACCESSORY ON SOME MODELS)
Drift cutters are used to cut a path through snow deeper than

the auger housing.
1. Loosen the wingnuts that secure the drift cutters to the

auger housing (see Figure 15).

2. Raise the drift cutters to the desired height.
3. Tighten the wingnuts.

Drift Cutter

Wingnut

Figure 15

HOW TO USE THE HEATED GRIPS

Heated grips are designed for use when the

temperature is below 32 degrees. Do not turn

on electric grips if temperature is above 32 de-

grees.

When the temperature falls below 32 degrees, use the

heated grips to keep your hands warm. Move the heated grip

switch to the ON position (see Figure 13). It will take a couple

of minutes for the grips to become warm. Because heated

grips can become very warm, we recommend that you wear

gloves. If you notice that the grips are too warm, turn off

heated grips.