John Deere ST1332 ユーザーズマニュアル

28

MTF−051059L

To access the spark plug, the snow hood must be removed

as follows:

1. Remove the choke control knob (see Figure 30).

2. Remove the ON/OFF key.

3. Remove the four mounting screws.

4. Slowly remove the snow hood (see Figure 31). Make

sure that the primer button hose and the ignition wire are
not disconnected.

5. To install the snow hood, first make sure that the primer

button hose and the ignition wire are connected.

6. Mount the snow hood to the engine and secure with the

four mounting screws (see Figure 32).

7. Align the tab on the choke control knob with the slot in the

snow hood (see Figure 33).

8. Connect the choke control knob with the choke shaft.

Make sure the choke control knob is properly installed.
If the choke control knob is not installed correctly, the
choke will not operate.

Figure 30

Choke Control Knob

Screws

Screws

Snow Hood

ON/OFF

Key

Figure 31

Snow Hood

Figure 32

Snow Hood

Carburetor

Choke Control

Knob

Tab

Slot

Figure 33