John Deere ST1332 ユーザーズマニュアル

30

MTF−051059L

If your snowthrower will not discharge snow, check the

control cable adjustment.  If it is correct, then check the

condition of the auger drive belt. If it is damaged or loose,

replace it (see Belt Replacement in this section of the

manual). 

1. Disconnect spark plug wire. 

2. Remove  screw  from  belt cover. Remove belt cover

(see Figure 36).

3. Loosen nut on auger idler pulley and move auger idler

pulley towards belt about 1/8 inch (3 mm) (see
Figure 40).

4. Tighten nut.

5. Have someone engage auger drive clutch.  Check ten-

sion on belt (opposite idler pulley).  Belt should deflect
about 1/2 inch (12.5 mm) with moderate pressure
Figure 37).  You may have to move idler pulley more than
once to obtain the correct tension.

6. Reinstall belt cover.

7. Whenever belts are adjusted or replaced, the cables will

need to be adjusted. (See Cable Adjustment in this sec-
tion of the manual).

8. Attach the spark plug wire.

Figure 36

Belt Cover

Screw

Figure 37

Auger

Drive

Engine

Pulley

1/2 inch

(12.5mm)

Deflection

Impeller

Pulley

Idler

Pulley

Engaged