Poulan 96198002800 ユーザーズマニュアル

18

TO REMOVE WHEELS (See Fig. 23)
•  Remove the klik pin and remove wheel from axle.
IMPORTANT: When installing wheel, be sure to use the in-

nermost hole in axle and the wheel hub hole.  To dis en gage 

drive system from the wheels (for pushing or trans port ing 

the snow thrower), remove klik pin from wheel hub and 

insert pin into the outermost hole in axle only.
NOTE: To seal punctures or prevent flat tires due to slow 

leaks, tire sealant may be purchased from your local parts 

dealer. Tire sealant also prevents tire dry rot and cor ro sion.

ENGINE
SEE ENGINE MANUAL.

CARBURETOR
Your carburetor is not adjustable. Engine performance 

should not be affected at altitudes up to 2,134 meters. If 

your engine does not operate properly due to suspected 

carburetor problems, take your snow thrower to a  service 

center/department.
ENGINE SPEED
Never tamper with the engine governor, which is factory set 

for proper engine speed. Overspeeding the engine above 

the factory high speed setting can be dangerous and will 

void the warranty. If you think the engine-governed high 

speed needs adjusting, contact a  service center/depart-

ment, which has the proper equipment and experience to 

make any necessary ad just ments.

TO ADJUST CABLE TENSION (See Fig. 24)
Adjust cable tension by turning the adjuster turn buckle, 

located on the right hand cable.  Grasp the long section 

tightly and turn the short section to lengthen the adjuster.  

Adjust until cable is snug.