Poulan 96192000900 ユーザーズマニュアル

16

1.      REMOVE GASOLINE FROM FUEL TANK - Drain gaso-

line from fuel tank into a suitable container, out doors, 
away from fi re or fl ame. Wipe up any spilled gasoline.

2.   REMOVE DISCHARGE CHUTE - Loosen locknut 

se cur ing chute rotator head to mounting bracket only 
enough to allow chute rotator head to be raised and 
dis charge chute to be removed from snow thrower.

3.   REMOVE BELT COVER - See “TO REMOVE BELT 

COVER” in this section of this manual.

4.      REMOVE ENGINE PULLEY - Remove bolt, lock wash er 

and fl at washer securing pulley to engine crankshaft.  
Remove outside (auger) pulley only from crank shaft.

5.   SEPARATE SNOW THROWER - With your assistant 

standing in the operating position holding the handles, 
re move the two (2) bolts and lock washers holding 
auger housing and frame together.

6.    REMOVE AUGER BELT from around pulley.

7.    RELIEVE TENSION ON TRACTION DRIVE BELT IDLER 

and remove traction drive belt from around pulleys.

HINT: Insert a 3/8" drive ratchet (in the “ON” position) into 
the square hole in idler arm and rotate ratchet clockwise 
to relieve tension.

8.    With tension relieved on idler, install new traction drive 

belt around pulleys and inside belt keepers.

9.      Place auger belt around and inside the groove of auger 

pulley only.

10. While your assistant slowly raises handles to rejoin 

the auger hous ing and frame assembly, pull up on the 
auger belt and squeeze sides together above pulley 
so belt is fully seated in groove of pulley.

11. Bring snow thrower completely together and check 

carefully for proper routing of belts.  If auger belt has 
become dislodged from the pulley (by catching the idler 
arm bracket while bringing snow thrower together), 
separate the snow thrower and re peat step 10.  Belt 
must be fully seated in pulley groove when bring ing 
the snow thrower together.

TO REMOVE WHEELS (See Fig. 21)
•      Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the in-
nermost hole in axle and the wheel hub hole.  To dis en gage 
drive system from the wheels (for pushing or trans port ing 
the snow thrower), remove klik pin from wheel hub and 
insert pin into the outermost hole in axle only.

12. Install the two (2) hex bolts and lock washers and 

tighten securely.

13.  INSTALL ENGINE PULLEY - Place belt in pulley groove 

and slide pulley on crankshaft.  Install fl at washer, lock-
washer and bolt and tighten securely (30-35 ft. lbs. 
torque).  Make sure belt is inside belt keeper.

14. INSTALL BELT COVER and two (2) screws. Tighten 

securely.

15.  INSTALL DISCHARGE CHUTE – See “INSTALL DIS-

 CHARGE CHUTE / CHUTE ROTATER HEAD” in the 
As sem bly / Pre-Operation section of this manual.