Echo 99944200532 ユーザーズマニュアル

 

Level 1 =  Easy to do. Common tools may be required.

   Level 2 =  Moderate difficulty. Some specialized tools may be required.

 

Tools Required:   4 mm L-Wrench

Parts Required:   POWER BLENDX

TM

 8 oz. (P/N 91014) or Lithium    

 

 

Base Grease.

Lower and upper drive shaft  must be lubricated with high tem-

perature automotive grease every 25 hours of operation, otherwise 

drive shaft assembly overheating and failure can result.

 1.  Remove the cutting attachment from the Power Pruner

TM

  shaft 

housing by removing the locating bolt (A), loosening the (2) two 

bolts (B) clamping the cutting attachment to the shaft housing, and 

sliding the cutting attachment off.

 2.  Remove lower flex cable, wipe clean, and apply a thin coat 15ml    

(1/2 oz.) of high temperature automotive grease.

 3.  Reinstall cable. Make sure cable end engages upper drive shaft 

adaptor.

 4.  Slide the cutting attachment onto the shaft housing until the hole 

in the neck of the cutting attachment is aligned with the hole (C) in 

the housing (It may be necessary to rotate the saw chain slightly to 

align the internal pinion and drive shaft.)

 5.  Insert locating bolt (A) and tighten to snug.

 6.  Tighten bolts (B), clamping the cutting attachment onto the hous-

ing.

Drive Shaft

Grease

1

Every 25 hours of use

Guide Bar

Inspect/Clean/Lubricate

2

Before Each Use

Saw Chain

Inspect/Sharpen/Replace/Tension

2

Before Each Use

Screws/Nuts/Bolts

Inspect/Tighten/Replace

1

Before Each Use

IMPORTANT - Time intervals shown are maximum. Actual use and your experience will determine the frequen-

cy of required maintenance.