Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Multiquip
  4. DCA125SSIU
  5. ユーザーズマニュアル

Multiquip DCA125SSIU ユーザーズマニュアル

ダウンロード
ページ / 90
PAGE 28 — DCA125SSIU 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #3 (01/13/11) 
OUTPUT TERMINAL PANEL CONNECTIONS
UVWO TERMINAL OUTPUT VOLTAGES
Various output voltages can be obtained using the UVWO 
output terminal lugs. The voltages at the terminals are 
dependent on the position of the Voltage Selector Switch 
and the adjustment of the Voltage Regulator Control 
Knob.
Remember the voltage selector switch determines the 
range of the output voltage. The voltage regulator (VR) 
allows the user to increase or decrease the selected 
voltage.
3Ø-240/139 UVWO Terminal Output Voltages
1.  Place the voltage selector switch in the 3Ø 240/139 
position as shown in Figure 18..
Figure 18. Voltage Selector Switch
3Ø-240/139V Position
2.  Connect the load wires to the UVWO terminals as 
shown in Figure 19.
Figure 19.  UVWO Terminal Lugs 
3Ø-240/139V Connections
3.  Turn the voltage regulator knob (Figure 20) clockwise 
to increase voltage output, turn counterclockwise to 
decrease voltage output. Use voltage regulator 
adjustment knob whenever fi ne tuning of the output 
voltage is required.
Figure 20. Voltage Regulator Knob
3Ø-208V/1Ø-120V UVWO Terminal Output Voltages
1.  Place the voltage selector switch in the 3Ø 240/139 
position as shown in Figure 21.
Figure 21. Voltage Selector Switch
3Ø-240/139V Position
2.  Connect the load wires to the UVWO terminals as 
shown in Figure 22.
Figure 22. UVWO Terminal Lugs
3Ø-208/1Ø-120V Connections Connections
NOTICE
To achieve a 3Ø 208V output   the voltage selector 
switch must be in the 3Ø-240/139 position and the 
voltage regulator must be adjusted to 208V..