Multiquip DCA800SSK2 ユーザーズマニュアル

The AC ammeter and AC voltmeter gauges are controlled by 
the AC ammeter and AC voltmeter changeover switches.

Both of these switches are located on the control panel and 
DO NOT effect the generator output. They are provided to 
help observe how much power is being supplied, produced 
at the UVWO terminals lugs.

Before taking a reading from either gauge, confi gure the 
Voltage ChangeOver Board (Figure 12) which produces 
the desired output voltage. 

Ø Position

Place the AC Voltmeter ChangeOver Switch (Figure 13) 
in the WU position and observe the phase to phase voltage 
reading between the W and U terminals as indicated on 
the AC Voltmeter Gauge (Figure 14).

Place the AC Ammeter ChangeOver Switch (Figure 16) 
in the U position and observe the current reading (load 
drain) on the U terminal as indicated on the AC Ammeter 
Gauge (Figure 16). This process can be repeated for 
terminals V and W.

The ammeter gauge will only show a reading when 
the  Output Terminal  Lugs are connected to a load 
and in use.