Multiquip DCA800SSK2 ユーザーズマニュアル

Set the 

1. 

battery ON/OFF switch (Figure 39) to the "ON" 

position.

Place the 

2. 

engine speed switch in the "LOW" position 

(Figure 40).

Place the 

3. 

MPEC control switch in the MANUAL 

position to start the engine (Figure 41).

Press and hold the engine pre-heat button (Figure 42). 

4. 

Verify that the pre-heat lamp is lit. Continue pressing  
button until pre-heat cycle is complete. After completion 
of the pre-heating cycle, the light will go OFF and the 
engine will start up automatically.

Once the engine starts, let the engine run for 12 

5. 

minutes. Listen for any abnormal noises. If any 
abnormalities exist, shut down the engine and correct 
the problem. If the engine is running smoothly, place 
the engine speed switch (Figure 43) in the HIGH (up) 
position.

The generator’s frequency meter (Figure 44) should be 

6. 

displaying the 60 cycle output frequency in HERTZ.

The generator’s ACvoltmeter (Figure 45) will display 

7. 

the generator’s output in VOLTS..

If the voltage is not within the specifi ed tolerance, use 

8. 

the voltage adjustment control knob (Figure 46) to 
increase or decrease the desired voltage.

Verify that the 

9. 

engine running status LED on the 

MPEC module (Figure 47) is lit (ON) after the engine 
has started.

The ammeter (Figure 48) will indicate 

10. 

zero amps with 

no load applied. When a load is applied, the ammeter 
will indicate the amount of current that the load is 
drawing from the generator.