Multiquip DCA25USIXF ユーザーズマニュアル

ページ / 98
1
DCA25USIXF/DCA25USI2XF — OPERATION AND PARTS MANUAL — REV. #2 (07/26/11) — PAGE 9
DCA-25USIXF/DCA-25USI2XF— RULES FOR SAFE OPERATION
SAFETY INFORMATION
ELECTRICAL SAFETY
  DANGER
DO NOT
 
„
 touch output terminals during 
operation. Contact with output terminals 
during operation can cause electrocution, 
electrical shock or burn.
The electrical voltage required to 
 
„
operate the generator can cause severe 
injury or even death through physical contact with live 
circuits. Turn generator and all circuit breakers OFF 
before performing maintenance on the generator or 
making contact with output terminals.
NEVER
 
„
 insert any objects into the output 
receptacles during operation. This is 
extremely dangerous. The possibility exists 
of  electrical shock, electrocution or 
death. 
 
Backfeed to a utility system can cause 
 
„
electrocution and/or property damage. 
NEVER  connect the generator to a 
building’s electrical system without 
a transfer switch or other approved 
device. All installations should be 
performed by a licensed electrician in accordance with 
all applicable laws and electrical codes. Failure to do so 
could result in electrical shock or burn, causing serious 
injury or even death.
Power Cord/Cable Safety
  DANGER
NEVER
 
„
 let power cords or cables lay in water.
NEVER stand in water 
 
„
while AC power from the 
generator is being transferred to a load.
NEVER
 
„
 use damaged or worn cables or cords when 
connecting equipment to generator. Inspect for cuts in 
the insulation. 
NEVER
 
„
 grab or touch a live power 
cord or cable with wet hands. The 
possibility exists of electrical shock, 
electrocution or death. 
Make sure power cables are securely connected to the 
 
„
generator’s output receptacles. Incorrect connections
may cause electrical shock and damage to the 
generator.
NOTICE
ALWAYS 
 
„
make certain that proper power or extension 
cord has been selected for the job. See Cable Selection 
Chart in this manual.
Grounding Safety
  DANGER
ALWAYS
 
„
 make sure that electrical circuits are properly
grounded to a suitable earth ground (ground rod) per 
the National Electrical Code (NEC) and local codes
before operating generator. Severe injury or death by 
electrocution
 can result from operating an ungrounded
generator.
NEVER
 
„
 use gas piping as an electrical ground.