Multiquip DCA-100SSVU ユーザーズマニュアル

4. Verify that the Engine Running

status LED  on the MPEC unit
(Figure 44) is ON (lit) after the
engine has been started.

Manual Start-up Procedure

The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.
Direct exhaust away from nearby personnel.

1. Place the 

main, G.F.C.I., and  aux. circuit breakers

(Figure 38)  in the OFF position prior to starting the engine.

2.  Make sure the  the 

voltage change-over board has

been configured for  the desired output voltage.

3. Connect the load to the 

receptacles  or  the  output

terminal lugs as shown in Figure 13. These load
connection points can be found on the output terminal
panel and the output terminal panel’s hard wire hookup
panel.

4. The output terminal lugs are protected by a plastic cover.

Remove this cover to gain access to the terminals.
Tighten terminal nuts securely to prevent load wires from
slipping out.

5. Close all engine enclosure doors (Figure 39).

3. Once the engine starts, let it engine run for 1-2 minutes.

Listen for any abnormal noises. If any abnormalities
exists shutdown the engine and correct the problem.
If the engine is running smoothly, place the engine
speed switch (Figure 43) in the “

HIGH” (up) position.

2. Once the engine glow plugs have been warmed, place

the 

MPEC Control Switch in the MANUAL  position to

start the engine (Figure 42).

NEVER! manually start the engine with the main, GFCI
or 

auxiliary circuit breakers in the ON (closed) position.

1.  Place the engine speed switch (Figure 41) in the “

LOW ”

(down) position.