Multiquip DCA-180SSV ユーザーズマニュアル

1. Perform steps 1 through 5 in the 

Before Starting  section

as outlined in the 

Manual Starting Procedure.

2. Place the 

engine speed switch (Figure 53) in the HIGH

position

4. Continue operating the generator as outlined in the

Manual Start-up procedure (start at step 5).

When the generator is set in the
AUTO mode, the generator will
automically start in the event  of
comercial power falling below a
prescribed level by means of a
contact closure that is generated
automatically by a transfer switch.

Before connecting this generator to any
building’s electrical system, a 

electrician must install an isolation
(transfer) switch. Serious damage to the
building’s electrical system may occur
without this transfer switch.

When connecting the generator to a isolation (transfer)
switch, ALWAYS have power applied to the generator's
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.

When running the generator in the AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in the auto mode.

When the MPEC 

is placed in the AUTO position,
the engine glow plugs will be
warmed and the engine will start
automatically.

When starting generator in AUTO mode use the "

Start-up" procedure except where noted (see below).

The 

Engine Speed Switch must be set to the “High”

position when running in the 

Auto-Start mode. Failing to

set the switch in the proper position can result in damage
to your generator when it turns on.

3. Place the 

MPEC Control Switch (Figure 54) in the AUTO

position