Multiquip DCA-15SPX4 ユーザーズマニュアル

240/120V output voltages can be obtained using the 

Terminal Lugs. Use the voltage regulator (VR) to either in-
crease or decrease the selected voltage.

2. Turn the voltage regulator knob (Figure 13) clockwise  to

increase voltage output, turn counterclockwise to
decrease voltage output.

2. Turn the voltage regulator knob (Figure 13) clockwise  to

increase voltage output, turn counterclockwise to
decrease voltage output.

1. Connect the load wires to the 

Output Terminal  Lugs as

shown in (Figure 12)

The ammeter gauge (Figure 15) on the generator control panel
has been provided to help observe how much current (amps)
is being supplied to the load from the 

output terminal lugs,

GFCI receptacle or any auxulliary receptacles if installed.

The 

ammeter gauge will only

show a reading when the 

Terminal Lugs or auxillary
receptacles are connected to a
load.

1. Connect the load wires to the 

Output Terminal  Lugs as

shown in (Figure 16)

3. Observe that the output voltage either increases or

decreases by monitoring the voltmeter (Figure 14)
reading.