Multiquip DCA-45SSIU3 ユーザーズマニュアル

To shutdown the generator, use the following procedure:

1. Switch the MAIN,  AUX and GFCI circuit breakers

(Figure 53) to the “OFF” position (no load).

1. To  shut-down the engine in the event of an emergency,

switch the 

MAIN, GFCI and LOAD (Figure 55) circuit

breakers to “OFF” position.

2.   Turn the ignition switch key to the “STOP” position.

2. Let the engine cool by running it for 3-5 minutes with no

load applied (circuit breakers in the off position).

3. Place the ignition switch (Figure 54) in the “STOP” position,

remove the key and store in a safe place.

4.     Remove 

all loads from the generator.

16.  Turn the 

main, GFCI, and aux.  circuit breakers to the

“ON” position (Figure 51).

17. Observe the generator's ammeter (Figure 52) and verify

it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if the load is in use.

18. The generator will run until manually stopped or an

abnormal condition occurs.