RCF TX1000 ユーザーズマニュアル

24

BELT-CLIP TRANSMITTER EQUIPPED WITH:
•   ON/OFF switch for transmitter activation.

•   MUTE switch.

•   A green LED indicating the battery charge status.

•   A trimmer to adjust the input sensitivity.

•    A red “PEAK” LED 

     (indicating the maximum admissible level of the input signal).

•   A socket with screw-lock connector for the microphone.

•  Connect a clip-on (“Lavalier”) mic. LA 1000 or a headworn mic. HE 1002 

by inserting the mini-jack into the transmitter socket and tightening it 

thoroughly.

•  Remove  the  cover  of  the  battery  compartment  using  a  coin  or  a 

screwdriver.

•    Insert  a  9 V  alkaline  battery  according  to  the  polarity  indications  (+/-) 

printed on the bottom.

•  Put the cover back on the battery compartment and press it down to 

secure it in its seat.

•   Switch on the transmitter by setting the ON/OFF switch to ON. The green 

LED lights up (the LED stays lit during normal operation; it flashes when 

the battery is low and should be  replaced).

•   Make sure the MUTE switch is set to ON.

•   Check the transmitter is working correctly: one of the two green LEDs 

A/B on the respective receiver should be lit.

•   Adjust the input sensitivity appropriately (using a screwdriver) using the 

SENS trimmer located on the upper part of the transmitter (during normal 

use,  increase  the  sensitivity  so  the  red “PEAK”  LED  flashes  occasionally 

but does not remain lit continuously).