Roland XV-5080. ユーザーズマニュアル
162
Chapter 5 Creating a Performance
K.L (Part Keyboard Range Lower)
Range:
C -1–G9
Specifies the lowest note that will cause the Part to play its
sound.
sound.
K.U (Part Keyboard Range Upper)
Range:
C -1–G9
Specifies the highest note that will cause the Part to play its
sound.
sound.
The Lower value cannot be set to a value greater than Upper
value, or vice versa. If you attempt to do this, the two values
will change simultaneously.
value, or vice versa. If you attempt to do this, the two values
will change simultaneously.
U.F (Part Keyboard Fade Width Upper)
Range:
0–127
This determines what will happen to the Part’s level when a
note that’s higher than its specified keyboard range is
played. Higher settings produce a more gradual change in
volume. If you don’t want the Tone to sound at all when a
note above the keyboard range is played, set this parameter
to 0.
note that’s higher than its specified keyboard range is
played. Higher settings produce a more gradual change in
volume. If you don’t want the Tone to sound at all when a
note above the keyboard range is played, set this parameter
to 0.
Selecting the Patch, and Setting
the Volume, Pan, Pitch, and
Polyphony
the Volume, Pan, Pitch, and
Polyphony
PERFORMANCE Part #1 page
([PERFORM] - [F3 (Part)])
([PERFORM] - [F3 (Part)])
fig.05-007.e_70
Patch (Part Patch)
Type (Part Type)
Range:
PAT/RHY
Selects the Patch (PAT) or Rhythm Set (RHY) the Part will
play.
play.
Group (Part Group)
Available Settings:
Selects the group to which the desired Patch or Rhythm Set
belongs.
belongs.
* It is not possible to select XP-A–H unless a wave expansion
board is inserted into the corresponding slot. (Quick Start; p.
3)
3)
* It is not possible to select CARD unless a SmartMedia card is
inserted into the XV-5080 CARD slot.
Number
Selects the desired Patch or Rhythm Set by its number.
Level&Pan (Part Level&Pan)
Part Level
Available Settings:
Sets the volume of the Part. This setting’s main purpose is to
adjust the volume balance between Parts.
adjust the volume balance between Parts.
Part Pan
Available Settings:
Specifies the stereo position of the Part’s sound. L64 is far
left, 0 is center, and 63R is far right.
left, 0 is center, and 63R is far right.
Tune (Part Tune)
Octave Shift (Part Octave Shift)
Range:
-3– +3
Adjusts the pitch of the Part’s sound up or down in units of
an octave (+/-3 octaves).
an octave (+/-3 octaves).
Coarse (Part Coarse Tune)
Range:
-48– +48
Adjusts the pitch of the Part’s sound up or down in semitone
steps over a range of +/-4 octaves.
steps over a range of +/-4 octaves.
Fine (Part Fine Tune)
Range:
-50– +50
Adjusts the pitch of the Part’s sound up or down in one-cent
steps (1/100th of a semitone) over a range of half a semitone
up or down.
steps (1/100th of a semitone) over a range of half a semitone
up or down.