Roland F-100 ユーザーズマニュアル
6
Introduction
Assembling the F-100
Make sure that another person is on hand to help with the assembly and setup.
To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you assemble and
move the piano, to make sure that you do not drop it on your hands or feet.
Always carry out this procedure with the F-100 lying horizontally, with the rear panel facing down.
■
Check the Parts
Before you begin assembling the F-100, check that all the
parts were supplied.
parts were supplied.
You will also need to have a Phillips screwdriver.
fig.st1
The speaker box can also be installed so that it faces toward
the rear instead of toward the front. Having the speaker box
face out the rear of the instrument allows the speakers to be
directed toward listeners when the back of the instrument
faces the audience.
the rear instead of toward the front. Having the speaker box
face out the rear of the instrument allows the speakers to be
directed toward listeners when the back of the instrument
faces the audience.
fig.stsp
■
Assembly Procedure
• At first, assemble the entire unit in a temporary fashion,
without really tightening the screws.
Then, after checking the overall alignment of the boards
(and gently shifting certain parts where necessary), go
around and tightly fasten each of the screws.
Then, after checking the overall alignment of the boards
(and gently shifting certain parts where necessary), go
around and tightly fasten each of the screws.
• Be careful when assembling the F-100, so as to avoid
scratching the side panels.
When securing the screws, lay the entire unit sideways
with the rear side of the F-100 at the bottom.
with the rear side of the F-100 at the bottom.
1.
Tighten the screws on one of the side panels to
secure that side panel the F-100 and speaker box
(four locations).
secure that side panel the F-100 and speaker box
(four locations).
Install so that the speaker cable at the rear of the speaker
box extends to the right side (the side where the F-100’s
[Power] switch is located).
box extends to the right side (the side where the F-100’s
[Power] switch is located).
fig.st02-2
2.
Align the projection of the pedal board with the
hole in the side panel, and use a screw to fasten
the pedal board (one location).
hole in the side panel, and use a screw to fasten
the pedal board (one location).
fig.st02-2
3.
Align the hole in the other side panel with the
projection of the pedal board, and use a screw to
fasten the pedal board (one location).
projection of the pedal board, and use a screw to
fasten the pedal board (one location).
fig.st02-2
Front
1
F-100
2
3
4
Pedal Board
5
6
Speaker box
Speaker cable
Side panel right and left
(Left)
(Right)
Front
Rear
Rear
Cross section
Screw x 10
Cap x 10
(and some spare caps)
Normal direction
When facing to the rear
Front
Rear
Front
Rear
Speaker
box
Speaker
box
box
F-100
Side with
rounded
corners
facing out
rounded
corners
facing out
Speaker box
Side panel
(Right)
Screws
Pedal Board
Screw
Side with
rounded
corners
facing out
rounded
corners
facing out
Side panel
(Left)
(Left)
Screw
F-100.e.book 6 ページ ２００３年８月２９日 金曜日 午前９時４８分