Roland 5100009796-02 ユーザーズマニュアル
53
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign an RPN or NRPN to a controller.
1
Press the [ACT] button and [
] button simultaneously.
2
Slightly move the controller to which you want to assign a control
change message.
change message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
The number of the selected controller will blink in the display.
3
Verify that the display, then press the [ENTER] button.
fig.lcd-rpn.eps
4
Turn the [VALUE] knob until “RPN”
appears in the display.
appears in the display.
* If you want to assign an NRPN message, get “NRPN” to appear in the display. The
rest of the procedure is the same as for RPN.
fig.lcd-midichannel.eps
5
Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
specified MIDI transmit channel.
6
Use the [VALUE] knob to specify the desired MIDI transmit channel.
7
Press the [ENTER] button.
fig.lcd-rpnmsb.eps
8
Use the [VALUE] knob to select the
desired RPN MSB (CC#101) or NRPN
MSB (CC#99).
desired RPN MSB (CC#101) or NRPN
MSB (CC#99).
9
Press the [ENTER] button.
10
Use the [VALUE] knob to select the desired RPN LSB (CC#100) or
NRPN LSB (CC#98).
NRPN LSB (CC#98).
11
Press the [ENTER] button.
12
As appropriate for the controller type, specify the desired “Button
mode setting” (p. 55) or “Virtual center click setting” (p. 55).
mode setting” (p. 55) or “Virtual center click setting” (p. 55).
RPN/NRPN Assignment
Data entry MSB (CC#6) range
Data entry LSB (CC#38) range
Port
0–127 (00–7FH)
not transmitted
PORT1
A-300_500_800C_e.book 53 ページ 2010年2月22日 月曜日 午後9時13分