Creative LONGboard 61 ユーザーズマニュアル

ページ / 44
Mode d’Emploi 
41 
REGULATORy INFORMATION
Notice for the USA
FCC Part 15:  This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one or more of the following measures: 
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. 
This device complies with part 15 of the FCC Rules. Operation is subject to the following 
two conditions: 
This device may not cause harmful interference, and
1. 
This device must accept any interference received, including interference that my 
2. 
cause undesired operation. 
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of 
the FCC Rules, this device must be installed with computer equipment certified to comply 
with Class B limits. All cables used to connect to the computer and peripherals must be 
shielded and grounded. Operation with non-certified computers or non-shielded cables may 
results in interference to radio or television reception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of 
this device could void the user’s authority to operate the device. 
WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, 
a separation distance of 20 cm or more should be maintained between the antenna of this 
device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended. The 
antenna used for this transmitter must not be co-located in conjunction with any other 
antenna or transmitter.