Creative E-MU ユーザーズマニュアル

Basic Operations

E-MU Systems

34

This function sends MIDI program changes to your external gear on the currently 
selected Basic MIDI channel. (At the same time, it edits the program change number for 
the current MIDI channel in the active patch. See 

more info.)
Note that the program change send includes a send of Bank Select MSB and Bank 
Select LSB according to the settings for those parameters on the same MIDI 
channel in the current patch. See 

.



1. Press the Edit button.
2. Press the Send Prog Change keyboard key.
3. Select the desired program change number from 0-127 using the Data Slider, 

Octave Transpose buttons, or Numeric Keyboard Keys.

4. Press Enter to send the program change.
5. Press Home to exit without sending the program change. (This also leaves the 



1. Make sure the Program Change Mode button’s LED is lit. If not, press the 

button to light it.

2. Use the Direct Patch Select numerical buttons to enter a one- to three-digit 

program change number. Use the button labeled “10” to enter a “0.”

3. Do one of the following:

• If Zones are enabled, press the corresponding Zone button for the MIDI 

channel you want to send the Program change across. If you want to send 
the Program Change over the current MIDI channel, press Enter or the 
Program Change Mode button (they will be blinking).

• If Zones are not enabled, press Enter or the Program Change Mode 

button (they will both be blinking).

This parameter allows you to select the MIDI Bank Select MSB (most significant 
byte) that will be used when sending program changes via the Prog Change, PGM 
Browse Mode or PGM Send On Recall features.
Select a Bank MSB from 0-127. Note that this merely edits the Bank Select MSB 
setting for the current MIDI channel in the active patch. It does not cause a MIDI 
message to be sent immediately.
For more information on MIDI Bank Select commands, see 

.

X Board.book  Page 34  Wednesday, April 12, 2006  10:44 AM