Creative E-MU ユーザーズマニュアル

E-MU Xboard Control

Xboard

53

The Control Pedal input accepts either a 
momentary-on footswitch or a continuously 
variable pedal. Like the other controllers, an initial 
setting, CC number and MIDI channel can be 
programmed. The MIDI Channel field allows you 
to set the MIDI channel for the mod wheel. This 
field is unavailable unless the “MIDI Channel 
Number Per Control” option is selected (See 

.) The default setting for the Control Pedal is CC 64, which is the standard 

MIDI sustain pedal number.

These settings allow you to transpose the keyboard 
up or down in octave or semitone steps. The octave 
transpose range is ±4 octaves. The semitone transpo-
sition range is -64 to +63 semitones.

Note: Semitone Transpose is disabled when Zones are enabled.

This section allows you to program the high and 
low keys for latch mode, as described on 

You can also turn latch mode on or off by pressing 
the amber-colored button. Note that you cannot 
set a low key number higher than the high key, or 
a high key number lower than the low key.

When this parameter is set to On, the 
current initial value (position) settings 
of the 16 Controller Knobs, the Pitch 
Wheel, the Mod Wheel and the 

Footpedal will be stored in the patch when the patch is stored via the Xboard front 
panel. Note that this setting has no effect upon storage of patches from Xboard Control, in 
which all settings are always stored to the Xboard exactly as they appear onscreen. 

 

If this parameter is Off, the existing continuous controller settings are retained.

MIDI Channel

CC Channel No

Initial 

 

Pedal Setting

X Board.book  Page 53  Wednesday, April 12, 2006  10:44 AM