Tascam DP-008 ユーザーズマニュアル

TASCAM DP-008

NOTE

You cannot enter MASTER REC mode if

•

you have not set an OUT point.
If you try to enter MASTER REC mode

•

when the length of the interval between

IN and OUT points is too short, a “trk too

short” pop-up message appears and you

cannot enter MASTER REC mode.
In MASTER REC mode, you cannot change

•

the OUT point.
Some playback functions and other

•

functions do not work when the unit is

in master recording mode. If you try to

use one of these functions, an “In Master

Mode” pop-up message appears.

4 Press the playback (Á) key while

pressing and holding the record (–) key

to start master recording.
The record (–) key indicator lights.

Regardless of the prior recorder position,

recording starts from the 00:00:00:00 point

(start of song).

Use the

LEVEL

and

PAN

knobs as

necessary to control the mix. These

adjustments do affect the recorded stereo

master track.
Recording automatically ends when the

recorder position reaches the OUT point.

After it ends, do the following to listen to

the master track that you created.

5 Press the

REC MODE

key to open the

RECORDER MODE

screen.

6 Turn the

DATA

wheel to select

MASTER

PLAY

7 Press the

F4 (

EXEC

)

key to put this unit

into master playback mode and return to

the Home Screen.

8 Press the playback (Á) key to play the

stereo master track that you created.

The playback signal of the stereo master

track is output through the

PHONES

LINE OUT

connector, so it can also be

dubbed to an external stereo recorder.

9 If you are satisfied with this stereo

master track, press the

REC MODE

key

to open the

RECORDER MODE

screen. Turn

the

DATA

wheel to select

MULTI TRACK

and press the

F4 (

EXEC

)

key to put the

unit into multitrack mode (ordinary

mode) again and return to the Home

Screen.

If you do not like the stereo master track

you made, follow the above procedures

to make a master recording again. The

new stereo master track replaces the

previous stereo master track.

NOTE

To listen to the recorded stereo master

track in a saved song, load the song, set the

recorder mode to MASTER PLAY and press
the playback (

) key to start playback.

TIP

A stereo master track can be copied to any

track pair among tracks 1–8 by creating a

“clone” track (see “CLONE TRACK (track

duplication)” on page 62).

Undoing operations (undo)

This unit allows you to undo an operation or

recording that did not work as planned or was

otherwise unsatisfactory. Undo can be used on

many ordinary operations, including editing

and recording operations. This unit has two

types of undo functions. Single undo can be

used with a simple key press, while multi-undo

allows you to return to and undo a specific past

operation.

NOTE

The UN/REDO indicator lights when single

undo or multi-undo has been conducted

and there are undone operations that can

be redone.

6 – Basic Recording