Samson L2400 ユーザーズマニュアル

6

24BIT DIGITAL EFFECT SECTION
The L2400 and L3200 feature built-in, 24 Bit Digital Multi-

effects Processor(s) with 100 dazzling, studio quality 

effects like Delay, Chorus, Flanging and lush Reverbs 

including Halls, Plates and Rooms.  In addition, there are 

multi-effects presets that have two effects combined 

together.  For example, Delay and Reverb or Reverb and 

Chorus, to name a few. The following section describes 

the features control knobs and layout of the powerful on-

board digital Multi-effects section.

The L Series mixers Multi-effects Processors feature a 

dual digit, seven-segment numerical Effects Display for 

showing the effects PROGRAM number from 00 - 99.  You 

will see the PROGRAM numbers change as you scroll 

through the effects pre-set using the DSP SELECT control. 

When the Effects Display shows two straight lines through 

the center of each segment, the effects are turned off 

and the EFX ON switch is in the out position. See section 

number 25 below. 

This section identifies the ten banks of built-in DSP 

effects presets.  The first bank of 10 presets have been 

programmed with common effects for live performance, 

and the following banks are set up in groups by the types 

of effects.

The SELECT control knob is a continuously variable 

encoder, or tweaker, that allows you to call up one of 

the 100 built-in digital effects presets.  Simply rotate the 

SELECT knob to scroll through the preset programs using 

the Effects Display to choose the effect number you want.
21 - TO AUX 1 - Effects Return to Aux 1 control knob 

The TO AUX 1 control is used to adjust the level of the 

effects from the built-in digital Multi-effect that’s being 

sent to the AUX 1 monitor bus.  This allows you to add the 

DSP effects to the signal in your monitor speakers. Turn 

this knob up if you want to hear the effect in the AUX 1 

monitor mix. 
22 – TO AUX 2 - Effects Return Control 

The TO AUX 2 control is used to adjust the level of the 

effects from the built-in digital Multi-effect being that’s 

being sent to the AUX 2 monitor bus.  This allows you 

to add the DSP effects to the signal in your monitor 

speakers. Turn this knob up if you want to hear the effect 

in the AUX 3 monitor mix. 
23 – TO AUX 3- Effects Return Control 

The TO AUX 3 control is used to adjust the level of the 

effects from the built-in digital Multi-effect being that’s 

being sent to the AUX 2 monitor bus.  This allows you 

to add the DSP effects to the signal in your monitor 

speakers. Turn this knob up if you want to hear the effect 

in the AUX 3 monitor mix.