Roland SP-555 ユーザーズマニュアル

 

If you press [FILTER] so the button is lit, you’ll be able to 
control the cutoff frequency of a filter by moving your hand 
above the controller.

[FILTER] will blink when you’re within the effective range of 
the D Beam controller.

Press [FILTER] + a pad to select the desired combination of 
filter type and resonance.

• Pad 1: Low-pass filter
• Pad 2: High-pass filter
• Pad 3: Band-pass filter
• Pad 4: Notch filter

Higher pads select a filter with stronger resonance.

If you press [TRIGGER] so the button is lit, you’ll be able to 
play the desired pad by moving your hand above the 
controller.

To specify the pad, hold down [TRIGGER] and press the 
desired pad 1–16.

 

Be aware that if you select Trigger and then switch the pad 
bank, the pad that will be triggered will not change, but the 
sample that will be played will be different.

 

You can use [TRIGGER] + CTRL 3 knob to specify the velocity 
at which the pad will play.

 

If you’re using Roll to play the pad, and you turn the D Beam 
controller [TRIGGER] on, you’ll be able to use the D Beam 
controller to control the volume of the roll.

 

If the SP-555 is in a state in which pressing a pad does not 
play a sample (e.g., if [PATTERN SELECT] is lit or if [EFFECT 
ASSIGN] is lit), you won’t be able to use the D Beam controller 
to trigger pads.

SP-555_e.book 39 ページ ２００７年６月２５日　月曜日　午前９時９分