Siemens TC12 ユーザーズマニュアル
TC12 Installation, Commissioning & Maintenance Handbook
2.4.6
Power cable disconnected/faulty.
fuse blown.
PC
faulty.
ulty.
PC Not running TC12 software. Check software
nd re-boot PC.
Software has failed - ignore all other SIP LEDs/audio
re driven). Re-boot PC. Re-install software
Note. If it becomes necessary to replace an IMD distribution box or the
2.4.6
odem on modem PCB -
module
others OK
Modem/IMD cable faulty
correct MDF connection
PCB
h modem PCB to transformer PCB
cable, disconnected/ faulty
Modem/IMD cable not connected/ connected to
wrong four D-types/ cable faulty
wrong four D-types/ cable faulty
B
PSU faulty on PSU PCB
No PSU PCB to modem PCB cables attached
IMD card/cables installed incorrectly/ faulty
2.4.6.4
Symptom Possible
Reason
Power LED not on
PSU PCB to Digital Output PCB ribbon cable not
connected or faulty.
connected or faulty.
Problems with PSU PCB i.e. fuse blown/no power to
PSU/faulty PSU
PSU/faulty PSU
Watchdog Fail LED ON for
all PCBs connected
all PCBs connected
Check SIP Panel PC 1 LED. If on, PC software is not
running - reboot PC
running - reboot PC
.2 PC Failure
Symptom Possible
Reason
PC not Powered
PC Switched off.
Mains plug fuse blown
Master switch panel off/
SIP PC 1 LED ON
Digi I/O card card/cables installed incorrectly.
Digi I/O card fa
installation a
(softwa
and re-boot.
and re-boot.
associated PCB they must be replaced in pairs.
.3 Modem Communication Problems
Symptom Possible
Reason
No communication from one D-type disconnected from IMD distribution
m
m
In
OTU
Disconnected/faulty
No communication from all
Incorrect Mode set on Modem PCB.
four modems on Modem
Radial system wit
No power to modem PCB - check power LEDs,
check modem PCB to PSU PCB cable
check modem PCB to PSU PCB cable
Telephone line connection problem at MDF
No communication from all
No mains connection to PSU PCB
modems in one rack
Low Voltage side of PSU not connected on PSU PC
Digital Output PCB Problems
666/HE/43100/000
Page 51
Issue 9