JVC KM-H3000U ユーザーズマニュアル

Press MENU. The Wipe Pattern buttons 
illuminate.

Press a Pattern button to select the 
corresponding menu.

Auto-follow displays the menu for a selected function 
when the button for that function is pressed. 
Auto-follow is always active — when you press any 
button on the control panel that has a corresponding 
menu, the menu is automatically displayed.

Some menus have multiple pages. When the NEXT 
button is lit, multiple menu pages exist. Press NEXT 
to move to the next menu page. Press and hold 
NEXT and then press MENU to move to the previous 
menu page.

Some menus contain sub-menus. Press the knob 
corresponding to the sub-menu to access it. Press 
and hold the NEXT button and then press the 
RECALL button to return from the sub-menu.

If you wish to return to the first page of a top-level 
menu, Press and hold the NEXT button and then 
press the STORE button.

• You can exit the menu system by pressing any 

button other than a Wipe Pattern or source button 
while the menu system is active.

The control panel has three continuously rotatable 
pushbutton knobs located below the display screen. 
The knobs are used to select and alter menu options.

• Rotate the knob to adjust the corresponding value. 

• Double-press a knob to default the value currently 

associated with that knob.

The buttons illuminate to indicate one of four states:

• Glow — When a button on the board is lit with the 

Panel Glow color, it is in a resting state. All buttons 
are lit with the Panel Glow color unless selected, 
turned on, in use, or on-air.

• On-air — Source buttons corresponding to on-air 

sources are red.

• Menu — A button is green when the associated 

menu is displayed.

• On/Selected — Several buttons are On/Off 

buttons. If the button feature is turned off, it is lit 
with the Panel Glow color. If the button feature is 
turned on, the button is lit with a brighter shade of 
the Panel Glow color.

For More Information on...
• adjusting the panel glow, refer to the section 

Insert films can be installed into most switcher 
buttons. Insert films allow you to name specific 
source buttons, control buttons, or replace the default 
button names with those of a different language.

All inserts must be cut to the dimensions indicated for 
small (1) or large (2) buttons. Using insert films that 
do not meet the recommended criteria may 
damage the button cap and diffuser.

Remove the Cap Assembly (1) from the Switch 
Assembly (2) by grasping it firmly and pulling 
away from the control panel surface.

0.504"

0.444"

0.528"

0.468"