Korg Triton Studio ユーザーズマニュアル

Here you can edit sample data (waveform data). Editing 
operations such as deleting unwanted portions of the wave-
form, reversing the waveform, or lowering the sampling fre-
quency can be performed in detail while viewing the 
“sample waveform display.”

Selects the multisample that contains the sample you wish 
to edit (

☞0–1a).

Selects the index of the sample you wish to edit. Your edit-
ing will affect the sample of the index that you select here, 
and the waveform will appear in the “sample waveform dis-
play” (

☞0–1a).

An index can also be selected by holding down the 
[ENTER] key and playing a note on the keyboard. The 
index that includes this note will be selected. The key 
you played will be the base key, and will be displayed 
in gray in “Keyboard & Index” (

☞“Keyboard & Index” 

0–1a).

(

☞0–1a)

This shows the sample number and name for the selected 
index, and the range. If you modify “Sample,” the sample 
you specify here will be assigned to this index (

☞0–1b). The 

range of the index is shown at the right.

Sample waveform display
This displays the waveform of the selected sample. The hor-
izontal axis is the sample address (time axis), and the verti-
cal axis is the sample level.

The thick line above the display border indicates the portion 
of the entire sample waveform that is displayed. As you 
zoom-in on the time axis, this will indicate which portion of 
the entire waveform is currently being viewed. If a stereo 
multisample or sample is selected, the L channel sample 
data of the multisample will be displayed in the upper half, 
and the R channel sample data in the lower half.

This specifies the range (start address and end address) of 
the sample that will be edited by page menu commands. 
(This is shown in sample address units.)
The range you specify here will be highlighted in the “sam-
ple waveform display.”

To audition the selected range, press the SAMPLING 
[START/STOP] key. The sample in the area between 
“Edit Range Start” and “Edit Range End” will sound at 
the pitch of the currently selected key (displayed in 
gray) (

☞“Keyboard & Index” 0–1a).

 When setting “Edit Range Start” and “Edit 

Range End,” it will be possible to select these only to loca-
tions where the waveform level is ±0 (i.e., where the wave-
form crosses the center line of the “sample waveform 
display”). You can use the [VALUE] slider, [VALUE] dial, 
and [

] [

] keys [0]–[9] to automatically search for zero-

cross addresses. By using the numeric keys you can search 
for the zero-cross address nearest to the value that you 
input.
Off (unchecked):

 “Edit Range Start” and “Edit Range End” 

can be set in increments of one. This is the normal setting.

(

☞2–1c)

This has no relation to the setting of the [TEMPO] knob.

These buttons let you zoom-in and zoom-out the “sample 
waveform display” along the horizontal axis (sample 
addresses) or vertical axis (sample level).

By zooming-in on the horizontal direction, you can move 
from the overall display where the waveform is shown as a 
solid line (1X magnification) to 2X or 4X magnification. 
(With 1X magnification, the display resolution of the LCD 
will be the same as the resolution of the sample addresses. 

1–1

1–1a

1–1b

1–1c

Zoom-in vertically

Zoom-out vertically

Zoom-out horizontally

Zoom-in horizontally

Maximum
horizontal zoom-out

1x horizontal zoom-in