Korg Triton Studio ユーザーズマニュアル

Select this option when you do not use any effects. The Insert 
Effect section outputs unprocessed signals and the Master 
Effect section mutes the output.

This effect simulates the frequency response characteristics of 
guitar amplifiers. It produces a realistic effect as though the 
sound were being played through a guitar amp. It is also 
effective for organ and drum sounds.

This effect compresses the input signal to regulate the level 
and give a “punchy” effect. It is useful for guitar, piano, and 
drum sounds. This is a stereo compressor. You can link left 
and right channels, or use each channel separately.

This parameter selects whether the left and right channels are 
linked to control both signals simultaneously, or whether each 
channel is controlled independently.

The “Sensitivity” parameter sets the sensitivity of the compressor. 
If this parameter is set to a higher value, lower level sounds will 
be boosted. With a higher Sensitivity, the overall volume level is 
higher. To adjust the final volume level, use the “Output Level” 
parameter.

This parameter controls the attack level.

The Limiter regulates the input signal level. It is similar to the 
Compressor, except that the Limiter compresses only signals 
that exceed the specified level to lower unnecessary peak sig-
nals. The Limiter applies a peaking-type EQ to the trigger sig-
nal (which controls the degree of the Limiter effect), allowing 
you to set any band width to be covered. This effect is a stereo 
limiter. You can link left and right channels, or use each chan-
nel individually.

a

Amplifier Type
Selects the type of guitar amplifier

SS, EL84, 6L6

b

Wet/Dry

Dry, 1:99...99:1, Wet

Sets the balance between the effect and dry sounds

Src

Off...Tempo

Selects the modulation source of the effect balance

Amt
Sets the modulation amount of the effect balance

–100...+100

a

Envelope Select

L/R Mix, L/R Individually

Determines whether the left and right channels are linked or used 
separately 

☞

b

Sensitivity
Sets the sensitivity

1...100

☞

c

Attack
Sets the attack level

1...100

☞

d

EQ Trim
Sets the EQ input level

0...100

e

Pre LEQ Gain [dB]
Sets the gain of Low EQ

–15.0...+15.0dB

Pre HEQ Gain [dB]
Sets the gain of High EQ

–15.0...+15.0dB

f

Output Level
Sets the output level of the compressor

0...100

☞

,

Src

Off...Tempo

Selects the modulation source for the compressor output level

Amt

–100...+100

Sets the modulation amount of the compressor output level

g

Wet/Dry

Dry, 1:99...99:1, Wet

Src

Off...Tempo

Amt
Sets the modulation amount of the effect balance

–100...+100

+