Korg 2E ii ユーザーズマニュアル

1 Press the [F1] (“Sample”) key to access the SMPL 

2 Press the [REC/WRITE] key.

3 At the moment that you wish to start sampling, 

Sampling will start.

It is a good idea to allow a bit of extra time before 
you start and after you stop sampling.

4 At the moment that you wish to stop sampling, 

Sampling will stop.

A 140 BPM drum phrase has now been sampled. 
The sample will automatically be assigned to 
“SMPL.”

Sampling will stop automatically if the remaining 
amount of memory reaches zero.

5 Listen to the sampled sound, and assign a name to 

Press the C2 note or the [AUDITION] key, and the 
sampled sound will play. After you have verified 
the sound, assign a name to the sample (

(e.g., LOOP1-140 BPM). Up to 14 characters can be 
input as the name of a stereo sample (the two char-
acters -L and -R at the end are fixed). When you 
assign a name to either the L or R channel, the other 
sample will be named automatically.

Next we will delete unwanted portions from the sam-
ple, and make settings so that the sample will be 
looped smoothly.

By default when the power is turned on, sampled 
sounds will be looped automatically. (1.1: Record-
ing, Input/Pref page “Auto Loop On” On)

1 Press the [MENU] key to access the page menu.

2 Notice that 0000: LOOP1-140BPM -L is selected for 

3 Press the [F2] (“Edit2”) key to access the Edit2 

The waveform data of the currently selected sample 
will be displayed.

The selected sample is a stereo sample. The L and 
R waveforms will be displayed alternately when 
you press the [F3] (“L/R”) key.

4 Use “S (Start)” to set the start address, “LpS (Loop 

The sample will sound as follows.
When looping is on: S 

→ E → LpS → E → (continue 

repeating LpS 

→ E)

When looping is off: S 

→ E

Use the [ ], [ ] to select “S (Start)” (highlighted), 
and use the [VALUE] dial etc. to specify the location 
at which the sample will begin sounding. The verti-
cal line in the display will move accordingly.

As necessary, you can press the [F4]–[F7] keys to 
expand or shrink the waveform display. Zoom will 
expand/shrink the display starting at the selected 
“S (Start),” “LpS (Loop Start),” or “E (End)” 
points.
If you check “Zero (Use Zero),” locations where 
the waveform is at zero will automatically be 
found and selected when you use the [VALUE] 
dial etc. to set “S (Start),” “LpS (Loop Start),” or 
“E (End)” 

points. This makes it easy to set these 

points to addresses that will not produce clicks or 
noise.

For this example, set “LpS (Loop Start)” and “S 
(Start)”

 to the same value.

If desired, you can make a dotted vertical line 
appear in the sample waveform display to indicate 
the BPM. If you use this function with waveforms 
that have a specific BPM, it will be easier to make 
accurate settings for “E (End).”
Press the [F8] (“UTILITY”) key to access the utility 
menu, and press the [F7] key to select “Grid.” 
Press the [F8] (“OK”) key. The following dialog 
box will appear.