Korg Electric Keyboard ユーザーズマニュアル

4

Press the [F5] (“Name”) key to move to the text dialog 
box, and specify the “Volume Label” (☞BG p.43).
When the dialog box appears, “Volume Label” will show 
the volume label that had been specified before format-
ting. If a media that has no volume label or a non-DOS 
media is inserted, this will indicate “NEW VOLUME.”

5

Specify the initialization format. Normally you should 
use Quick Format to initialize the media, and use Full 
Format

 if an error message of “Media not Formatted” 

appears.

 Selects this if the media has already been 

physically formatted. Since only the system area of the 
media need be formatted, this will require less time.
Full Format:

 Selects this when formatting media that has 

not been physically formatted. You should also select this 
type of formatting if writing errors occur frequently with 
this media.

It is not necessary to perform a Full Format on SCSI 
media that has been physically formatted at 512 bytes/
block. Perform the Quick Format for such media.

The TRITON Le cannot format media with a format of 
other than 512 bytes/block (such as 640 MB, 1.3 GB MO 
disks etc.).

6

To format the media, press the [F8] (“OK”) key. To cancel 
without formatting, press the [F7] (“Cancel”) key.
A maximum of 4 GB can be formatted on an external 
SCSI device connected via the EXB-SMPL (sold sepa-
rately).

This displays information on the media that is selected by 
“Media Select.”
☞ 1.1–1c: Media select

The volume label of the media.

The specified SCSI ID. If the TRITON Le’s internal Smart-
Media slot is selected, “–” will be displayed.

The type of media.

The vendor ID, product, and product version, etc.

The type of format. If not formatted, this will indicate 
“Unformatted.”

The capacity of the media (in bytes).

The free capacity of the media (in bytes).

The write protect status of the media. This will indicate 
“On” if protected, or “Off” if not protected.

This will indicate “Yes” if the media of the selected device 
can be removed (e.g., SmartMedia, MO disc, removable 
hard disk). If the media is fixed, this will be “No.”

■

This command allows you to re-mount a connected SCSI 
device if the EXB-SMPL option is installed.

1

From the Utility menu, select “Scan SCSI device.”
The currently-connected SCSI devices will be re-scanned 
(if the EXB-SMPL option is installed). Once scanning is 
completed, any valid SCSI device can be selected in 
“Media Select.”

Never connect or disconnect a SCSI cable while the 
power of the TRITON Le or of a SCSI device is turned 
on. Doing so can cause irreparable malfunctions.

1.1–4a

1.1–4b